Morrison Bros. Co. 710FSS Series Solenoid Valve - Normally Closed

Manuals and Information:

710F Spec Sheet

Normally closed solenoid valves are used to help prevent the accidental siphoning of a product from a tank in the event of a leak downstream below the liquid level. They are generally installed on the dispensing side of a fuel system pipeline. The valve opens upon the receipt of an electronic signal such as when a dispenser or pump is switched to the on position.

• Operates at 120 volts AC (24, 208, 220, 240, & 480 volts AC, and 12, 24, and 48 volts DC also available)
• Minimum operating temperature is -40°F
• Includes a continuous duty Class H standard coil. Other options are available
• Must be mounted in a horizontal pipeline with solenoid vertical and upright
• No differential pressure is required to open the valve
• Connects to a conduit. 18" lead wire provided
• Enclosure is watertight and rated for hazardous locations on aboveground fuel storage tanks- NEMA 3, 4X, 7 and 9; groups C and D
• Available in Viton or Teflon seals (3" only in Viton)
• Has a built-in expansion relief
• Flanged connections ANSI 150 RF
• Maximum viscosity rating of 60 Centistokes
• Manual overide feature available (Fig. 710FMO or 710FSM)

• Body: 304 Stainless Steel
• Seals: PTFE

• CSA listed (File No. 108921, Model Z1314); Class I, Groups C and D; Class II, Groups E, F, and G. Class III, T3C

NOTE: It is strongly recommended that a line strainer with 100 mesh be installed at the inlet of this valve. Failure to do so may cause the valve to malfunction and void the warranty.

NOTE: Product can only be pumped in the direction of the flow arrow. Not designed for use as overfill prevention or process control valve.