*Image is a representation of this item. Actual item may vary.*
Hover over image to zoom
Facet GNG-230 GNG Series Go-No-Go Military Monitor Cartridges
1-3/4 in.x 30-7/8 in., Flow Direction: outside to inside, 1-3/4 in. OD
Ships From Manufacturer
Select Model & Quantity:
Model # | Description | Price | Qty |
---|---|---|---|
GNG-230 | 1-3/4 in.x 30-7/8 in., Flow Direction: outside to inside, 1-3/4 in. OD | $86.35 |
Facet - GNG-230 - GNG Series Go-No-Go Military Monitor Cartridges
MAXIMUM WATER REMOVAL, SOLIDS HOLDING
CAPACITY AND SHUTDOWN PROTECTION
ASSURES CLEAN, DRY FUEL
The Facet 2 in. (51 mm.) nominal outside diameter GNG
Series Go-No-Go monitor cartridges perform three
jobs they absorb free and emulsified water to less
than 2 ppm; remove ultra-fine solids; and shut down
system flow when hit with a localized slug of water,
giving you clean, dry fuel. The GNG Series Go-No-Go
monitor cartridges are designed to flow from the
outside to inside at a rate of 1 gallon (3.79 liters) per
inch of length.
Go-No-Go monitor cartridges meet the latest edition
of Military Specification (MIL-M-81380C(AS) for
Monitor, Contamination, Aviation Fuel Dispensing
Systems.
The presence of water or solids in the incoming fuel will
be indicated by an increase in the pressure differential
or a decrease in the flow rate as the cartridges
reach their maximum capacity for solids, water or
a combination of both. When either happens, the
cartridges should be replaced.
Each GNG Series Go-No-Go monitor cartridge is
constructed of various water absorbent media, plus
fine filtration layers wrapped around a molded center
tube for balanced flow and structural strength all
encased in a protective outer sock material. The
end cap material is of injection molded, glass-filled
nylon which provides superior strength and ease of
maintenance. This material gives excellent support
for the o-ring on the mounting/adaptor end.
- Tested and qualified to meet the latest edition of Military Specification (MIL-M-81380C(AS) for Monitor, Contamination, Aviation Fuel Dispensing Systems
- New conductive end caps with anti-static properties which greatly reduce the possibility of static discharge during the fueling process
- Multi-layered media for increased solids holding, water removal and shutdown protection
- Structurally withstands a minimum of 150 psid
- Less than 0.3 mg/liter of solids in effluent
- Less than 2 ppm of water in effluent
- Buna-N gaskets-Viton available on request
- Not adversely affected by exposure to temperatures varying from -65°F to 160°F
Model | Nominal Length | Outside Diameter (OD) | Inside Diameter (ID) |
---|---|---|---|
GNG-230 | 30-7/8 in. (780 mm.) | 1-3/4"in. (44 mm.) | 7/8 in. (29 mm.) |